Quick and Dirty SolidWorks Macros by Lenny Kikstra
These macros are categorized as Quick and Dirty because all you have to do is run them.
These macros do not contain any interface, and the do not require any special setup files.
These are macros that I have written and have made freely available for your download and use.

Disclaimers: These macros are provided free of charge for personal use and/or reference. These macros may be freely distributed, provided the original copyright notices remain unchanged and intact. Most of these macros will work 32bit and 64bit versions of SolidWorks 2009 and later with minimal or no modification. These macros, and corresponding files, are provided as is. There are no warranties, expressed or implied, that these macros will perform as indicated, perform to users expectations, or complete a specific task. These macros will change the current SolidWorks document. Use these macros at your own risk. Back up your data before using this macro on any SolidWorks document.

This disclaimer was last modified on March 13, 2007 by Leonard Kikstra

Name/Size: CenterlineSymbol 664k Version/Date: 1.30 06/19/2010 Programmer/Copyright: Leonard Kikstra 2001-2010 Description: This macro will create a centerline symbol at a preselected point in a SolidWorks drawing.

Name/Size: IsoViews 659k Version/Date: 1.30 06/19/2010 Programmer/Copyright: Leonard Kikstra 2001-2010 Description: This macro will add/update 16 (4 Isometric, 4 Dimetric, 4 bottom ISO, 4 Bottom Dimetric) named views in this SolidWorks model. These named views can be referenced at any time while viewing the SolidWorks model, or they can be used within SolidWorks drawings.